Advertisement
SET UP
Plug the handset cord into the jacks on the handset and
base.
Plug one end of the supplied long telephone cord into the
jack on the bottom of the base. Plug the other end into a
modular phone jack.
If you mount the phone on the wall:
• If you mount the phone on a wall plate, use the sup-
plied short modular cord to connect the phone to the
modular jack in the wall plate.
• Attach the mounting bracket as shown.
• Press up on the handset cradle hook to remove it.
Then turn it over so its tabbed edge faces up and
press it back down into its slot.
Note: The phone company charges to install any neces-
sary jacks. The USOC number of the jack to be installed
is RJ11C.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to alert you
that parts inside the telephone present
a risk of electric shock. Do not open
the case.
This symbol is intended to alert you to
important
operating
instructions included in the papers with
the telephone.
USING THE PHONE
Press the switchhook to
disconnect a call.
Handset Cradle Hook
Turn to adjust the volume
to the desired level.
STORING/DIALING NUMBERS IN MEMORY
To store a number into memory:
1. Lift the handset and press
2. Enter the telephone number you want to store, up
to 16 digits in tone or pulse mode.
Note: To enter a 3.6-second pause, press
3. Press
4. Press
the cradle.
and
servicing
Use this holder to hold the handset
temporarily without disconnecting
a call.
The ring indicator flashes when
the phone rings, even when the
ringer is off.
STORE
.
REDIAL
again.
STORE
,
, or
, then return the handset to
©
RadioShack is a trademark used by Tandy Corporation.
Press
STORE
enter the phone number you want to store.
See "Storing/Dialing Numbers in Memory."
Press
to temporarily switch
to tone dialing when using pulse
service.
To dial a number in memory:
1. Lift the handset.
2. Press
,
, or
Testing Stored Emergency Numbers
.
If you store an emergency service's number (police, fire
department, ambulance) and you want to test the stored
number, make the test call during the late evening or
early morning hours to avoid peak demand periods. Re-
main on the line to explain the reason for your call.
ÐÐ
1996 Tandy Corporation.
All Rights Reserved.
once before and after you
Switch to
or
to
TONE
PULSE
match the type of service you
have.
Set
to
in a noisy
RINGER
HI
room or
in a quiet room. To
LO
turn off the ringer, set it to
OFF
.
You can still make calls with the
ringer off, and you can also
receive calls, if you hear
another phone on the same line
ring or see the ring indicator
flash.
Press
to dial the last
REDIAL
number dialed (up to 32 digits
in tone or pulse mode).
.
Advertisement
