Sears 721.88502800 Manual page 22

J. REMOVING THE TURNTABLE MOTOR
(1) Remove the glass tray and rotating ring.
(2) Remove the turntable shaft VERY CAREFULLY
by hand. (Figure 19)
(3) Remove the base plate by removing 8 screws
securing it to the oven cavity. (Figure 20)
(4) Disconnect the leadwire from the turntable motor
terminals.
(5) Remove the 1 screws securing the turntable motor
to the oven cavity ASS'Y. (Figure 21)
NOTES:
• Remove the leadwire from the turntable motor
VERY CAREFULLY.
• Be sure to grasp the connector not the wires when
removing.
K. REPLACING THE HUMIDITY SENSOR
(1) Remove the sensor by removing two screws
securing it to the air duct. (See Figure 22)
(2) Mount the new humidity sensor to the air duct.
7-11
Figure 22