Operating Humidifier Controls - Emerson MoistAIR MA1200 Owner's Manual

MA1200 Manual - 71233
4. Listen for air bubbles. Look for leaks
around the "Side Fill Cap" and valve
plunger.
5. If you hear air bubbles or see leaks,
retighten the "Side Fill Cap" and
repeat steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the
humidifier base to the right of the grille.
The "Side Fill Cap" must be facing out-
ward. When positioned properly, the
plunger will open and water will flow into
the base. The base will hold the entire
contents of the water bottle. Allow up to
one minute for the water to flow into the
base. Once the bottle is empty, remove it
and refill it as mentioned earlier. Return it
to the right side of the grille. The humidifi-
er is now filled to capacity.

Operating Humidifier Controls

The operating controls of your MoistAir
Quiet Comfort whole house humidifier
are located towards the front of the
humidifier.
Familiarize yourself with the controls.
Refer to the diagram of the control
area for the correct nomenclature used in
this manual.
To Operate the Controls
Power Button / Light
When the unit is plugged in and the
power button is pressed once the red
power light will come on. The power light
will stay on until the power button is
pressed again turning the unit off or until
the unit is unplugged.
Digital Display
The digital display will also show readouts
when the unit is turned on. Initially there
is a slight delay while the electronics cali-
brate. Two bars (- -) flash during this
time. Once calibration is complete a
ROOM humidity reading between 25% -
95% will be displayed. A flashing 25 dis-
7/12/05 2:36 PM Page 7
The water bottle may be filled at anytime
as necessary during operation. To benefit
from less frequent filling let the humidifier
exhaust both the water from the bottle
and base before filling.
The unit is now ready for operation.
play indicates that the room humidity is
less than 25 %.
Note: The default settings at initial start-
up are LOW fan speed and 65% SET
humidity. After desired settings are
selected by the user, they remain as
defaults as long as the unit remains
plugged in and there is no power
interruption. If the unit is unplugged the
original default settings are employed.
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms.
7
Digital Display
Function
Buttons
On
Refill
Light
Light
Bottle
Base