Using Your Tv As A Monitor - Radio Shack Anevision Color TFT LCD TV Quick Manual

To attach the
stand to the
TV, rotate the
locking knob
on the bottom
of the TV
clockwise until
the locking screw engages.
To remove the stand, rotate the locking knob
counterclockwise until the locking screw
disengages.
Using Your TV
1. Extend the rod antenna and press
on top of the TV to select VHF or
UHF
UHF. The TV starts scanning and stops
at the next active channel in the selected
band.
2. Press
CHANNEL
TV to tune to a different channel. The
tuning line on the screen aligns with the
selected channel number below the
screen.
3. To adjust the volume, press
or on top of the TV.
-
4. To adjust the picture to the desired
brightness, press
on top of the TV. The brightness also
changes with the screen's angle.
4
VHF/
or on top of the
) (
VOLUME +
or
BRIGHTNESS
)
Notes:
• In low temperatures, the TV screen
takes a few seconds to light, or it might
be slightly red in color. This is not a
malfunction. Normal operation occurs
after a few seconds.
• If reception is poor, adjust the length or
angle of the rod antenna. If inside a metal
or concrete building, moving closer to a
window might improve reception.

Using Your TV as a Monitor

You can play back the signal from an audio/
video component connected to your TV
using a Y-adapter cable (not supplied). Y-
adapter cables are available at your local
RadioShack store.
Connect the adapter's red plug to the
component's audio right output jack and the
adapter's white plug to the component's
audio left output jack. Then connect the
video cable's yellow plug to the
component's video output jack and the other
end to the
VIDEO INPUT
Then connect the adapter's stereo mini plug
into the
AUDIO INPUT
(
Note: Connecting an audio/video component
disables the TV's antenna.
jack on the TV.
jack on the TV.