Vehicle Battery Power; Using The Stand - Radio Shack Anevision Color TFT LCD TV Quick Manual

AC Power
You can power the TV using the supplied
AC adapter.
Caution:
You must use a regulated ITE
!
power source that supplies
12V DC and delivers at least
800 mA. Its center tip must be set to
positive and its plug must fit the TV's
jack. The supplied AC adapter
DC 12V
meets these specifications. Using an
adapter that does not meet these
specifications could damage the TV or
the adapter.
Insert the AC adapter's barrel plug into the
TV's jack. Then plug the other end
DC 12V
of the AC adapter into a standard AC outlet.
Cautions:
• Do not leave the adapter plugged into
the AC outlet or connected to the TV
when you are not using the TV.
• The adapter might become warm after
extended periods of use.

Vehicle Battery Power

You can power the TV from a vehicle's 12V
power source (such as a cigarette-lighter
socket) using the supplied DC adapter.
Caution:
You must use a power source
!
that supplies 12V DC and
delivers at least 800 mA. Its
center tip must be set to positive and its
plug must fit the TV's
supplied DC adapter meets these
specifications. Using an adapter that
does not meet these specifications could
damage the TV or the adapter.
Plug the DC adapter's barrel plug into the
TV's jack. Unplug the vehicle's
DC 12V
cigarette lighter and plug the large end of the
DC adapter into the cigarette-lighter socket.
Caution: Do not leave the adapter plugged
into the cigarette-lighter socket or connected
to the TV when you are not using the TV.
Note: If the TV does not operate properly
when you use DC power, be sure the
cigarette-lighter socket is clean and that the
adapter's plug is properly connected to the
socket.

Using the Stand

You can attach the supplied stand to the
bottom of the TV. This lets you tilt the TV to
the desired viewing angle and to obtain the
desired picture brightness.
You can also use the stand to permanently
mount the TV on a flat surface such as a
desk, shelf, or table. To mount the TV on a
flat surface, drive two screws (not supplied)
into the mounting holes at each end of the
stand to lock the stand in place, then attach
the TV to it.
jack. The
DC 12V
3