Advertisement
Connect the AC cord to power outlet.
Use the POWER key to turn on your HDT V.
Use the Setup Wizard to select your HDTV's location.
For the first time after powering on your HDTV, the Setup Wizard appears.
Press the CURSOR UP/DOWN key to select Home Mode or Shop Mode.
Setup Wizard (1/5)
Please select Home/Shop
Home Mode
Shop Mode
Home mode default settings are recommended for
in-home use. ENERGY STAR
qualified.
®
Shop mode is intended for in-store display and resets
video settings at Power On.
Cancel
Move
ENTER
Select
NOTE: Selecting Home Mode will qualify as an Energy Star rating.
Perform a Signal search.
Press the CURSOR UP/DOWN key to select Antenna, Cable, or Set Top Box.
Press the CURSOR ENTER key to enter the next step, and then start
Channel search for digital and analog channels.
Please allow the HDTV a few minutes to complete the process.
Setup Wizard (2/5)
Please select TV RF tuning band
Antenna
Cable
Set Top Box
P revious
Cancel
Move
ENTER
Select
HDMI, the HDMI Logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing LLC in the United States and other countries.
Aim Remote at the lower
left corner of the HDTV.
a
Setup Wizard (3/5)
Please check that the RF cable is connected properly.
Scan time may take over 20 minutes.
START
P revious
Cancel
Move
ENTER
Select
Finalize the completed Setup process.
Please allow the HDTV a few minutes to complete the process.
Use the EXIT key to finish the Setup Wizard.
You can now watch and enjoy TV programming on your HDTV!
Setup Wizard (4/5)
Searching. Please wait
Searching CH
Channel 4
Digital Channels Found
8
Analog Channels Found
8
50%
Cancel
ENTER
Select
Choose the correct Input source.
Use the INPUT key on your remote control to select from
the available Input sources on your HDTV.
NOTE: If you receive Satellite or Cable service through a set
top box, tune to the correct input on your HDTV and use the
receiver and its remote for channel viewing.
Si necesita ayuda en ESPAÑOL, marque al 1-800-877-5032 y un asesor
estará dispuesto a ofrecerle ayuda con cualquiera de sus dudas.
Use the following codes to program your cable or satellite provider's
remote control to work with your new HDTV.
Direct TV
10154, 960
(to activate INPUT feature)
Dish Network
590, 683, 589, 542, 652
Comcast
10154
Cox
0154, 0088
Verizon
0181, 0826, 0920
ATT
1045, 1062, 1095, 1380
NOTE: If these do not work, refer to your Cable or
Satellite manual.
Setup Wizard (5/5)
Congratulations. TV Setup is done.
EXIT
Exit
Advertisement
