Replacing The Lamp - Acer P7203 Series User Manual

38

Replacing the Lamp

Use a screwdriver to remove the screw(s) from the cover, and then pull out the
lamp.
The projector will detect the lamp life. You will be shown a warning message
"
as possible. Make sure the projector has been cooling down for at least 30
minutes before changing the lamp.
before changing the lamp.
To Change the Lamp
1 Turn off the projector by pressing the power button.
2 Allow the projector at least 30 mins to cool down.
3 Disconnect the power cord.
4 Find the "OPEN" button on side of the projector and push it to open the
cover. (Illustration #1)
5 Open the cover. (Illustration #2)
6 Remove the two screws that secure the lamp module.(Illustration #3)
7 Pull out the lamp module by force. (Illustration #4)
To replace the lamp module, reverse the previous step.
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
" When you see this message, change the lamp as soon
The lamp compartment is hot! Allow it to cool down
4
To reduce the risk of personal injury, do not drop the
1
3
2