Image Stabilizer - Canon EF-S 18-13Smm f Instruction

o
Image Stabilizer
Set the STABILIZER switch to ON.
If you are not going to use the image
stabilizer function, set the switch to 0 FF .
You can use the image stabilizer in AF or MF
mode.
This function provides optimal image stabilization
depending on shooting conditions (such as
shooting still subjects and following shots).
When you press the shutter button
halfway, the Image Stabilizer will
start operating.
Make sure the image in the viewfinder is
stable, then press the shutter button the
rest of the way down to take the picture.
The Image Stabilizer cannot compensate for a
blurred shot caused by a subject that moved.
The Image Stabilizer may not be fully effective if
you shoot from a violently shaking vehicle or
other transportation.
The Image Stabilizer consumes more power
than normal shooting, so fewer shots can be
taken if you use the function.
When shooting a still subject, it compensates for
camera shake in a!! directions.
It compensates for vertical camera shake during
following shots in a horizontal direction, and
compensates for horizontal camera shake
during following shots in a vertical direction.
Using a tripod also stabilizes the image.
However, depending on the kind of tripod and
shooting conditions, sometimes it may be better
to turn off the Image Stabilizer function.
The stabilizer is equally effective for hand-held
photography and photography with a monopod.
The image stabilizer function also operates when the
lens is used with an Extension Tube EF12 " or EF25 II.
If you set the camera's Custom Function to change the
assigned button to operate the AF, the Image Stabilizer will
operate when you press the newly assigned AF button.
I
1
)
I
I
i
: : i
i
I
.~---_._.-
. . ,\.-,n-n
I
)r7~­
~I,
STABILIZER
i !
ON. rOFF
f---
~-
(
....
-
--~--
~.~.~.---
".
L---.
L :
I
l:~~~-=-=.
f-----
ENG-6