Care And Maintenance; Shutting Off The Water And Electricity Supplies; Cleaning The Dishwasher; Preventing Unpleasant Odours - Hotpoint LFT 228 A Instruction Booklet

The filter assembly consists of three filters which remove
food residues from the washing water and then
recirculate the water. They should be cleaned if you wish
to achieve the best results in every wash.
Clean the filters regularly.
The dishwasher should not be used without filters, or if
the filter is loose.
• After several washes, check the filter assembly and if
necessary clean it thoroughly under running water,
using a non-metallic brush and following the instructions
below:
1. 1. 1. 1. 1. Turn the cylindrical filter C in an anti-clockwise
direction and pull it out (fig. 1).
2. 2. 2. 2. 2. Remove the cup filter B by exerting a slight pressure
on the side flaps (fig. 2).
3. 3. 3. 3. 3. Slide out the stainless steel plate filter A (fig. 3).
4. Inspect the trap and remove any food residue. NEVER
REMOVE the wash cycle pump (black detail) (fig. 4) . REMOVE REMOVE
REMOVE REMOVE
After cleaning the filters, replace the filter assembly and
fix it in position correctly; this is essential for maintaining
the efficient operation of the dishwasher.
• Disconnect the appliance from the electricity supply
and shut off the water tap.
• Leave the door of the appliance ajar.
• When you return, run a wash cycle when the
dishwasher is empty.
* Only available in selected models.
NEVER NEVER
NEVER NEVER