The Floor Care System - Floor Buffer - Kirby Sentria Owner's Manual

Optional Accessories
/!\ CAUTION:
FLOOR BUFFER SET-UP
Your Sentria
fer for wood or tile floors.
To use the Floor Buffer, you must first insert the Buffer
Brush into the Floor Buffer Nozzle.
Center the belt of the Buffer Brush in the middle area
1
between the tufts of the brush. >
Turn the Buffer Nozzle over and slide the ends of the
2
Brush into the slots at each end of the nozzle. The
Buffer Brush will only fit the correct way. >
Push the belt up against the Brush Roll with your finger. >
3
4 While holding the belt in place, use the handle on the
Belt Lifter to turn it left (counter-clockwise) until the
red arrows line up. The Belt Lifter hook will catch the
belt and stretch it upward into the nozzle. >
To avoid loss of control, do not stand unit on end for polishing. The To avoid loss of control, do not stand unit on end for polishing. The To avoid loss of control, do not stand unit on end for polishing. The
Tech Drive pedal must be in the neutral position during polishing Tech Drive pedal must be in the neutral position during polishing Tech Drive pedal must be in the neutral position during polishing
™
system can be used as an effective floor buf-
39