How To Use Your Dishwasher - Hotpoint BFV620 Instructions For Installation And Use Manual

D

How to use your Dishwasher

First of all.
- Turn on the water supply
tap completely.
- Add the correct amount
of detergent.
- Load the baskets
correctly.
- Check that the spray
arms rotate freely.
- Close the door securely.
- Press the ON-OFF button "A":
indicator light "B" comes on. Your
appliance is now on and ready to
be programmed.
Select the wash cycle.
To select the wash cycle, turn knob
"D" clockwise until the indicator on
the knob lines up with the number
or symbol for the wash cycle most
suitable for the type of dishes to
wash (see 'Programme Chart').
After a few seconds, you will hear
a short beep: the wash cycle has
started, it is not advisable to make
any changes from this point.
Indicator lights
Your dishwasher is fitted with indi-
cator lights (E) that come on to show
you at which point the wash cycle
is at.
Here are the symbols correspond-
ing to each cycle phase:
Starting from the indicator light on
the left moving towards the one on
the right: pre-wash, wash, rinses,
drying.
At all times, your dishwasher tells
you where it is at.
8
Modifying a wash cycle in
progress.
If you have chosen the wrong cycle
- You can modify the wash cycle in
progress, if it has only just started.
Turn knob "D" anti-clockwise and
set it to Reset, after a few seconds
you will hear 3 short beeps and
Indicator light "E" will go out to show
all the settings will have been can-
celled. You are now free to re-set
the correct wash cycle.
You've left out a dish?
Interrupt the wash cycle by press-
ing the ON-OFF button, insert the
dish you had forgotten and press
the ON-OFF button again.
The cycle will start up from where
you interrupted it.
Cycle end
The end of the wash cycle is indi-
cated by 2 short beeps and a flash-
ing drying phase indicator light .
Set the knob to the reset position to
clear all settings.
Warning!
Turn the appliance off by
pressing button "A", unplug the
appliance from the electricity
socket to cut off the power
supply; the power supply cable
should consequently be easily
accessible.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry better
due to the steam.
Empty the lower basket first.
There's been a power
failure or you opened the
dishwasher door
The wash cycle stops and then
restarts when the electricity comes
back on or when you close the door.