Care and Cleaning Troubleshooting Information for Test Labs After Sales Service Hotpoint Guarantee Notes Key Contacts Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance.
‘N’ LIVE ‘L’ Changing the Mains Lead A lead can be ordered from Hotpoint Service UK: 08709 066 066 or Republic of Ireland: 1850 302 220 If you have damaged the existing lead or require a longer one a charge will be made. It is strongly advised that this work is carried out by a qualified electrician.
2. DO NOT load dishes to wash that are soiled with ash, wax or paints. covered floor, ensure that the 3. DO NOT lean, sit or stand on any part of the dishwasher - this could openings on the underside are cause injury and/or damage the appliance.
Installation Choose where you want to install Cold water connection. your dishwasher, you can place it Connect the cold water supply hose so that its sides or back panel are to a 3/4 gas threaded connection, side by side with furniture or up taking care to screw it tightly onto against the wall.
Getting to know your Dishwasher E. Upper basket I. Bottom spray arm F. Top spray arm J. Salt container cap G. Basket height adjuster K. Washing filter H. Lower basket L. Detergent and rinse aid The Controls A. ON-OFF Button R.
Once you close the door, the wash cycle set previously will begin. Half load. Your dishwasher also allows you to wash half a load, to save water , electricity and detergent (use only half the amount). Before setting a wash cycle , press button "Q"...
To optimise wash performance and save on energy, try to use the dishwasher with a full wash load. If it takes some time to fill your dishwasher, use the soak cycle to avoid caked on food and build up of bad odours.
(you won't have to do this again next time) 3. Put the dishwasher funnel on the hole and pour in approximately two kilos of salt. It is normal that some water comes out of the container.
Warning Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the interior of the appliance.
• Highly absorbent materials such as sponges and towels should never be placed in a dishwasher. with the sharp parts at the bottom. • If in any doubt, check with the manufacturer on items suitability for dishwasher’s.
Going away DO NOT use solvents or abrasives If the dishwasher is not going to be to clean the exterior and rubber parts used for some time, carry out the of your appliance, do not use...
- The dishwasher must first be disconnected from the electricity supply before any repairs or other work can be carried out. Switch off at the mains socket and water supply and remove the plug.
Hotpoint appliance than us - the manufacturer" As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of replacement parts for the first 5 years when fitted by a Hotpoint engineer.
All Hotpoint appliances carry a fully inclusive 12 month parts and labour guarantee as well as free replacement parts for the first 5 years (except microwaves, selected integrated appliances and cooker hoods, which have a one year guarantee) provided that they are fitted by a Hotpoint engineer.
Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence in (Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays) Note: Our operators will require the following information: Merloni Elettrodomestici UK Ltd.
Need help?
Do you have a question about the BFI 680 and is the answer not in the manual?
Questions and answers