Led Indicators - D-Link DSS-24+ Manual

LED Indicators

The LED indicators of the Switch include Power, 100M, Link/Act
(Link/Activity), and Slot. The LED indicators are used to facilitate
monitoring and troubleshooting of the Switch. The following
shows the LED indicators for the Switch along with an
explanation of each indicator.
♦ Power This indicator operates when the Switch is turned on.
If this indicator is not lit, check the AC power connector to
ensure proper insertion of the power cord.
♦ 100M The LED indicator lights green when a 100 Mbps
device is connected to a respective port. If a 10 Mbps device
is connected to a respective port, the LED indicator is OFF.
♦ Link/Act These LED indicators are lighted green when
there is a secure connection (or link) to a device at any of
the ports. The LED indicators blink green whenever there is
reception
occurring at a port.
♦ Slot This LED indicator is lighted green when there is a
secure connection
100BASE-FX (SC type) module installed in the front panel.
Each port has its own LED, designated as I and II. See
100M and Link/Act indicator descriptions above for further
information.
Figure 3.3 The DSS-24+ Switch LED indicators
or transmission
(or
10/100 Fast Ethernet Switch Manual
(i.e. Activity— Act)
link) to an
7
of
optional two-port
data