Charging The Batteries - Rad2Go Q-33 Owner's Manual

CHARGING THE BATTERIES

Before you ride the Q33 for the first time, it is advised that the unit is to be fully
charged (4-6 hours) and fully discharged (ride until the battery gauge indicates low
battery) for at least three cycles to maximize the efficiency of the battery. After that,
you should continue to charge the battery frequently, at least once every 30 days to
IMPORTANT:
Do not leave the battery uncharged for more than 1 month; otherwise it will greatly
reduce the battery lifespan.
TIP FOR BATTERY CARE: Charge the battery after each use.
There are two options to charge your scooter
Option 1:
To charge the batteries, plug the charger into the charger
socket located on the rear side of the battery/ controller
compartment. Then plug the charger into a wall outlet.
Option 2: (for professional use only)
RIDING THE Q33
Once you have completed the initial charge you are ready to ride. Remember, this is
not a toy. The Q33 can reach speeds up to 12 mph depending on the terrain and the
weight of the rider. You must wear a helmet and ordinances that govern and/or restrict
the use of powered scooters. The laws and ordinances vary greatly from municipality
to municipality. It is your responsibility to know and abide by your local restrictions.
Remove the screws from the battery compartment
located at the front part of the footboard. Disconnect
the wires. Lift the battery box. Connect the battery and
charger using the charger convertible cable. Plug the
charger into the wall outlet.
prolong the battery lifespan.