Expanding Your System; How Plug 'N Power Works; Adding Call Pendants; Adding Lamp Modules - Radio Shack Emergency Phone Dialer Owner's Manual

49-2559.fm Page 13 Wednesday, August 18, 1999 3:29 PM

EXPANDING YOUR SYSTEM

This section offers some suggestions for
expanding your personal security sys-
tem and describes some of the accesso-
ries you can use with your Emergency
Phone Dialer. Visit your local Ra-
dioShack store for details.
HOW PLUG 'N POWER
WORKS
Plug 'n Power controllers, such as your
Emergency Phone Dialer's console,
send signals through your household
wiring. Plug 'n Power modules (sold
separately) receive the controller's sig-
nals and turn the connected devices on
or off.
Two types of codes (house codes and
unit codes) allow you to control groups
of modules or individual modules within
your home. Set the Emergency Phone
Dialer's console and the modules you
want it to control to the same house and
unit codes. There are 16 house codes to
choose from ( through
A
codes ( through ).
1 16
For more information about how house
and unit codes work, read the instruc-
tions supplied with the individual mod-
ules.
Note: Intercom systems that send voice
signals over existing electrical wiring
might interfere with the ability to control
modules from your console when the in-
tercom is in use. Intercom systems with
separate wiring will not cause this prob-
lem.

ADDING CALL PENDANTS

You can purchase additional call pen-
dants for added security or for other
family members. You must initialize
each pendant before it will work with
your system (see "Initializing the Call
Pendant" on Page 8).

ADDING LAMP MODULES

Lamp modules (Cat. No. 61-2682) let
you control lamps through your Emer-
gency Phone Dialer's console. If you ac-
tivate the console's alarm, the lamps
controlled by these modules flash on
and off for about 4 minutes or until you
), and 16 unit
P
press
You can also control lamp modules us-
ing an optional remote control.
Note: If you add a lamp module to the
system but do not add a remote control,
you must reset the module to turn off the
lamp if the console's alarm has been
tripped. Simply unplug the module and
plug it in again.
on the call pendant.
STOP
13