Control Locations; Electronic Controls; Fan Speed - LG LP126CD3A Manual

1.2 CONTROL LOCATIONS

• ELECTRONIC CONTROLS

The controls will look like one of the following.

FAN SPEED

• Every time you push this button, it cycles through the settings as follows:
{High(F2) → Low(F1) → High(F2) → Low(F1)}
TEMP
MODE
Push this button to cycle through the modes from COOL → FAN ○
-
→ HEAT→ COOL.○
- COOL○
• Fan runs continually for normal cooling operation.○
- ENERGY SAVER○
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit
will check the room air temperature to determine if cooling is
needed.○
- FAN○
• Fan operation without heating or cooling.○
- HEAT○
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME○
• You will usually use shut-off time while you sleep.○
• If unit is running, use Timer to set number of hours until shut-off.○
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 minutes, and once again
after another 30 minutes.○
• Push Timer to cycle through the settings from 1 Hour → 2 Hours → ... → 12 Hours maximum.○
Copyright ©2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
E/SAVE
'
F
HEAT
FAN FAN HIGH HIGH
COOL COOL LOW LOW TIMER TIMER
MODE FAN TIMER
POWER
• To turn the air conditioner ON, push this button. ○
To turn the air conditioner OFF, push the button
ON ON
OFF OFF
again.○
• This button takes priority over any other button.○
○
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room. ○
The temperature can be set within a range of
54° F to 86° F by increments of 2° F. ○
• The setting appears in the display.
- 5 -
LGE Internal Use Only