Casio fx-100MS User Manual page 6

Note: In this manual, the v symbol next to a sample operation
indicates degrees.
1Fix 2Sci 3Norm Specifies the number
of digits for display of a calculation result.
Fix: The value you specify (from 0 to 9) controls
the number of decimal places for displayed calculation results.
Calculation results are rounded off to the specified digit before being
displayed.
Example: 100 ÷ 7 = 14.286 (Fix 3)
Sci: The value you specify (from 1 to 10) controls the number of
significant digits for displayed calculation results. Calculation results
are rounded off to the specified digit before being displayed.
Example: 1 ÷ 7 = 1.4286 × 10
Norm: Selecting one of the two available settings ( Norm 1 , Norm
2) determines the range in which results will be displayed in non-
exponential format. Outside the specified range, results are displayed
using exponential format.
–2
Norm 1: 10
Example: 1 ÷ 200 = 5 × 10
1EngON 2EngOFF Specifies whether engineering symbols are
used (EngON) or not used (EngOFF) during value input. The "Eng"
indicator is displayed while EngON is selected.
1a+b 2r ∠ (CMPLX Mode/EQN Mode only) Specifies either
i
rectangular coordinates (
Mode/EQN Mode solutions. The "r ∠ " indicator is displayed while polar
r
coordinates (
1ab/c 2d/c Specifies either mixed fraction (ab/c) or improper
fraction (d/c) for display of fractions in calculation results.
1Dot 2Comma Specifies whether to display a dot or a comma
for the calculation result decimal point. A dot is always displayed
during input.
Dot: Period decimal point, comma separator
Comma: Comma decimal point, period separator
Initializing Calculation Mode and Setup
To return the calculation mode and setup to the initial defaults shown
below, press O1N(CLR)2(Mode)=.
Calculation Mode: COMP
Angle Unit: Deg
Exponential Display Format: Norm 1, EngOFF
Complex Number Display Format:
Fraction Display Format: a b/c
Decimal Point Character: Dot
x x
10
| |, | | 10
–3
b
E n g ON E n g OFF
a b i
+
∠ ) are selected.
–1
(Sci 5)
Norm 2: 10
(Norm 1); 0.005 (Norm 2)
) or polar coordinates (
a b i
+
E-5
x x
–9
| |, | | 10
e
i
a+b
d
d
d
e
∠ ) for CMPLX
r
10
r∠θ
e