Maytag 120-volt 60-Hz Installation Instructions Manual page 9

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Checklist for washer operation:
Check the following if the washer is not operating properly:
1. Power supply cord is plugged in.
2. Circuit breaker is not tripped or fuse is not blown.
3. Timer has been advanced to start of a cycle.
4. Water faucets are turned on.
5. Inlet and drain hoses are not kinked.
6. Washer lid is closed.
7. Inlet valve is not frozen if not protected from the weather.
8. Suds level. Excess suds will slow the spin and cause poor
rinsing. Operate the washer through a complete cycle with no
detergent. Use less detergent or a controlled suds type
detergent in future loads.
If you need assistance:
If you need assistance:
Contact your authorized Maytag
The Maytag Consumer Interaction Center will answer any
distributor. To locate your authorized Maytag
questions about operating or maintaining your washer not
Laundry distributor, or for web inquiries, visit
covered in the Installation Instructions. The Maytag Consumer
www.MaytagCommercialLaundry.com.
Interaction Center is open 24 hours a day, 7 days a week. Just
dial 1-800 NO BELTS (1-800-662-3587) - the call is free.
If you cannot locate your distributor, the Commercial Laundry
Support Center will answer any questions about operating
When you call, you will need the washer model number and serial
or maintaining your washer not covered in the Installation
number. Both numbers can be found on the serial-rating plate
Instructions.
located on your washer.
Just dial 1-800 NO BELTS (1-800-662-3587)—the call is free.
When you call, you will need the washer model number and serial
number. Both numbers can be found on the serial-rating plate
located on your appliance.
Commercial Laundry
®
® Commercial
Operating Tips
WARNING
Fire
Never place items in the washer that are dampened
with
No washer can
Do not dry anything that has ever had any type of oil on
it
Doing so can result
It is recommended that fiberglass items not be washed in coin-
operated washers. If these items are washed in the washer, run
the washer through a complete cycle to rinse any residue away
that might be left in the washer.
Typical full load sizes
Load Type Loading
Suggestion
Mixed Load 3 double sheets
4 pillowcases
6 pair shorts
8 T-shirts
2 shirts
2 blouses
8 handkerchiefs
Permanent 2 double or
Press 1 king size sheet
1 tablecloth
1 dress
1 blouse
2 slacks
3 shirts
2 pillowcases
Moving the Washer to a New Location
Remove the front legs from the base of the washer.
Place both rear leveling legs in the upper position and tape
securely.
Apply tape to the side and bottom of the cabinet near the
rear.
Open washer lid, wedge a blanket between the tub ring and
the cabinet top restricting the tub movement.
Front legs
Rear
legs
Handle washer gently. Do not drop washer while using hand
truck.
Load Type Loading
Suggestion
Heavy Work 3 pair pants
Clothes 3 shirts
1 coverall
4 pair jeans
1 overall
Knits 3 blouses
4 slacks
6 shirts
4 tops
4 dresses
Tape 2 sides
9