Kenwood KDC-MP242 Instruction Manual page 17

Installation
non-Japanese cars Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
~
~
Make sure that the unit is instailed securely in place If the
unit is unstable, it may malfunction (for example, the sound
may skip).
2
When the upper level is removed, remove the
lower two locations.
~
~
• The frame can be removed from the bottom side in the
same manner.
Japanese cars
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Insert the two removal tools deeply into the slots
on each side, as shown.
3
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
it.
• Be careful to avoid injury from the catch pins on the
removal tool
4
Pull the unit all the way out with your hands, being
careful not to drop it.
~18mm
!
MAX
__ I
05mm
@N
@T
;/@T/N
L..L----/-I/J-----
T:
Toyota cars
N: Nissan cars
8f...
~ :A~
05mm
/
~
~
T@
@
N
L....
' - -
Accessory@..for Nissan car
AccessoryG)..for Toyota car
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
English
I 17