Tub Front; Drum Assembly And Belt - LG DLE8377WM Training Manual

DRYER

TUB FRONT

DRUM, BELT, and PULLEY
DLE8377xM/DLG8388xM
DLE7177WM/DLE7188WM
1. Remove the top plate.
2. Remove the front cabinet.
3. Disconnect the door lamp (top)
and electrode sensor (bottom).
4. Remove the four screws holding
the front assembly.
5. Lift the tub front up and away.
1. Remove the drum front.
2. Reach in and remove the belt
from the motor and pulley.
3. Lift the drum out through the
front of the dryer. The belt
will still be around the drum.
4. To replace the drum, put the belt
around it and set into the dryer
to rest on the two rubber wheels
on the tub back. Let the belt
hang.
6. Replace the tub front, holding
the drum up so it can set on the
two rubber wheels on the tub
front.
7. Make sure the belt is around the
circumference of the drum near
the point where it usually rides.
8. Reach in through the front or the
side and loop the belt around
the motor shaft and the pulley.
Rotate the drum by hand a
couple of turns to seat it.
Page 46 of 60 TRAINING MANUAL