AEG L 98685 FL User Manual page 30

30
Problem
The appliance fills
with water and
drain immediate-
ly.
The washing re-
sults are not satis-
factory.
The internal lamp
is off.
After a steam
programme, gar-
ments are partial-
ly wet.
After a steam
programme, gar-
ments are not suf-
ficiently smooth.
The drum is emp-
ty and the display
shows there is
some weight in .
The drum is full
but the display
shows 0.0 kg.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
Possible cause
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
You set a not correct
temperature.
Too much laundry load.
The lamp is burned.
The appliance is not ac-
curately levelled.
A wrong STEAM pro-
gramme has been selec-
ted (e.g. Synthetic in-
stead of Cotton).
Excessive laundry load.
It is necessary to set a
tare.
You loaded the laundry
before to activate the
appliance.
Possible solution
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
To replace the lamp, contact the
service centre.
Check the levelling and adjust
the appliance by raising or lower-
ing the feet.
Note the composition of the fab-
ric.
Reduce the laundry load
Press button
the appliance and to activate it
again.
Press button
the appliance . Empty the drum
and obey to the necessary steps.
(Refer to 'Loading the laundy')
If the display shows other alarm mes-
sage, contact the service centre.
to deactivate
1
1 to deactivate