Swann PRO-781 Manual page 10

To mount the camera, use the supplied mounting hardware (screws). If you're
mounting onto a wooden surface, you can drive the screws directly into the wood.
You may need to drill guide holes first, particularly if mounting the camera onto
hardwood. If mounting on masonry or similar surface, use the included wall plugs.
The camera mounts to the flat surface, such as the underside of a ceiling or a
sturdy wall.
• Using the included star-key tool, remove the dome cover.
• Choose the most appropriate port to run the cable out of.
• If you're going to run the cable into the roof or ceiling cavity, then
prepare a hole in the ceiling which will line up with the hole in the
top of the dome base. Use a high-quality sealant to ensure complete
waterproofness.
• If you're planning to run the cable on the exterior of the ceiling/wall,
then undo the small protective cap on the side of the dome base and run
the cable out that way. Note that this will reduce the weather resistance
of the camera unless it is properly sealed with a high-quality sealant.
• Attach the dome base to the celing using the included mounting screws.
• Aim the camera, and adjust the zoom and focus controls to get the image that
you want. It can be really helpful to have a television or monitor on hand so
you can see what you're doing! Help from an able assistant never goes astray,
either.
• The dome cover only mounts one way - that is, the cable-out port on the
side of the dome base means that the cover will only slide on when correctly
oriented. If you've changed the default position of the camera, this may mean
you'll need to re-orient the plastic dome cover.
• On the underside of the dome cover there are two screws which are
responsible for holding the plastic dome in place.
• Using a precision screwdriver, loosen the two small screws, and slide the
tabs aside.
• Rotate the plastic component of the dome so that the transparent
window lines up with the orientation of the camera.
• Re-orient the tabs and tighten the screws to hold the plastic dome in
place.
• Re-attach the dome cover, and secure in place by tightening the screws.
10 10 10
Mounting