Disassembly & Reassembly - Samsung PN15VT / VO Service Manual

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
PN15VT/VO/HT/HO monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use with caution when
handling these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. To remove the Rear Cover, you must use the special opening jig tool.
3-1-1 Before making Disassembly
1. Disconnect the power cord from the monitor.
2. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base close to you.
3-1-2 Cabinet Disassembly
1. Remove the Stand from the monitor.
(Refer to Stand manual)
2. Incline the monitor by lifting the rear of the
monitor.
Figure 1
3. Push the Opening jig each groove along the
top of the monitor till it makes a "ttak" sound.
(2 grooves : Left and Right, Make sure each
snap is disengaged.)
PN15VT/VO
PN15HT/HO
4. Remove 2 screws on the Rear cover.
Figure 2
5. Pull the Rear Cover up off the monitor.
6. Remove the Shield.(TCO 99)
Figure 3
6. Using pinch-nose pliers or ling-nose pliers,
acrefully disconnect the Anode Cap from the
CRT.
Warning: Do not touch the Anode contact
on the CRT (High Voltage may
remain).
3-1