Schluter Systems DH E RS User Manual page 11

Adjustment procedure of the Smart mode:
1. First, switch to the Night mode by simultaneously pressing
down the + and - buttons and releasing them immediately.
2. From the Night mode, simultaneously press down the +
and - buttons for more than 3 seconds, until the
starts to blink, indicating that the adjustment of the Night
mode timer is effective. The figures that replace the
ambient temperature indicate the current timer adjustment.
If needed, adjust the timer by pressing down the + button
to increase the value, or the - button to decrease it. The
Night mode timer adjustment range is from 1 hour to 23
hours in the Smart mode. To quickly scroll through the
timer values, press and hold down the button.
Note: If you set the timer to any value exceeding 23 hours,
it will be impossible to activate the Smart mode and if
it was activated, the Smart mode will be deactivated.
3. Activate the Smart mode by simultaneously pressing down
the + and - buttons for at least 3 seconds. The
appear. If the Smart mode was already activated, the same
procedure should be used to deactivate it.
4. When the adjustment is completed, release the buttons
and wait for 5 seconds to exit the adjustment function.
Note: It is always possible to manually change the Day/
Night mode during a 24-hour cycle. In all cases, at
the end of the 24-hour cycle, the thermostat will
return to the Night mode and start a new cycle. It is
thus not necessary to readjust the Smart mode when
a manual change is made to the Day/Night mode. If
the thermostat is set off (--), the Smart mode will be
deactivated.
When the power is restored after a power failure for example,
the Smart mode is deactivated and its corresponding icon
will blink. The icon will stop blinking as soon as you press
down a button.
icon
icon will
11