Hoover Limited Owner's Manual page 4

4
ARROW
Rotate cord protector on cord until you see its arrow. (Fig. 4)
5
GROOVE
6
UPPER
HANDLE
CORD PROTECTOR
7
Pull cord tight.
Press cord into place at each of the three notches indicated. (Fig. 7)
Do not plug cleaner in until assembly is totally complete.
5
CORD
PROTECTOR
CORD PROTECTOR
UPPER
SLOT
HANDLE
With arrow on cord protector
pointing toward arrow on upper
handle, press groove in cord
protector into slot in upper
handle. (Fig. 5 and 6)
CORD
PROTECTOR
8
RAILS
9
RAILS
LOCK TAB
BRACKET
HOLE
10
HANDLE
BASE
STEP 4: Attach
handle
Note location of tapered rails on
bracket and on lower handle.
(Fig. 8)
With printed side of bracket
facing up, slide rails on bracket
onto rails on lower handle until
bracket snaps past the lock tab.
(Fig. 9)
Pull bracket toward bottom of
handle slightly to make sure
bracket is locked in place.
Make sure hole in bracket
aligns with hole in handle.
With ON/OFF switch to front,
place assembled handle onto
handle base of cleaner body.
(Fig. 10)
Rock handle side to side while
pushing down firmly. Extra
pushing effort may be re-
quired.
Continued
6