Remote Control Function - Cambridge Audio 540R V2.0 Service Manual

NO. & NA M E
1. Press this button to turn this unit on or
off.
Power On/Standby
2. Press it to select:
I nput M ode
3. With this unit in ST E R E O mode, only
Front L eft & Front R ight speakers and
Stereo
Woofer have output.
When receiving A nalog/digital PCM
4.
PL I I / NE O 6 signals.
5. For digital surround signals
DD E X /DT S E S
6. Press this button to choose one of the
DSP M ODE following surround modes: T HE AT E R ,
HA L L , PA SST HR U, MOV IE , MUSIC
and R OOM.
7. Press this button repeatedly to reach your
desired compression dynamic range.
Dynamic
8. Under the Pro L ogic 5.1CH or DT S
L F E Tr im 5.1CH mode, press this button and adjust
the volume to set the L ow Frequency
output level
9. To balance speakers in Dolby Digital or
Dolby Pro L ogic mode.
Test Tone
10. Select channels by pushing this button,
C H Select then use volume key to balance speakers
11.
Press this button to turn on/off the output
Sub On/Off
of subwoofer.
12. Press this button to set the delay time for
Delay the Dolby digital/Dolby Pro L ogic modes.
13. Under PR O L OGIC II or Digital state, it
SPK Setup
can change the desired Speaker Setting
shown on the display.
Press this button to access the AV
14.
OSD R eceiver configuration settings by using
the OSD menus.
Press this button to mute the sound, push
15.
M ute again to cancel the mute function.
Cambridge Audio Azur 540R V2.0 AV Receiver
DE SC R I PT I ON
Digital or A nalog mode.

Remote Control Function

NO. & NA M E
16.
- Direction button.
/ Volume up
- Press these buttons to increase the
volume.
17.
- Direction button.
/ Tune down
- Tuner frequency down.
18. Press this button when you want to enter
the OSD setup menu.
E nter
19.
- Direction button.
/ Tune up
- Tuner frequency up.
20.
- Direction button.
/ Volume down - Press these buttons to decrease the
volume.
21. Press this button to alternate between FM
Tuner A M /F M and A M.
22. Press this button for B ass / Tr eble
adjustment, then press Vol up and Vol
B ass/ Treble
down to adjust the level.
23. Press this button to select the 6.1 analogue
6.1 Dir ect input.
24. In FM state, press this button, the current
program type appears on the display, using
PT Y
Tuning +/- to select the program type you
desire.
25. A llocates and memorizes radio stations
A PS automatically.
26. With R DS, press this button repeatedly to
Display have PS (program name) or CT (current
time).
27. Press this button to alternate between
Ster eo / M ono Stereo and Mono mode when listen to FM
broadcast.
Pressing this button to store the current
28.
Store frequency.
Pressing this button to select A uto /Manual
29.
M ode tuning mode and Preset mode.
Press the corresponding button according
30.
I nput Selector to your desired selection.
DE SC R I PT I ON
5