Fcc Statement - Honeywell TE529ELW User Manual

Remote Sensor
Temperature
Proposed operating range
with alkaline batteries
Proposed operating range
with lithium batteries
Temperature resolution
Humidity
Proposed operating range
Resolution
RF Transmission Frequency
Maximum number of Remote sensors
RF Transmission Range
Temperature sampling cycle
Calendar and Clock
12 hour display in hh : mm format
Date Format: Month – Day format
Day of week: User- selectable in 5 languages
(English, Spanish, French, German, Italian)
Dual 4-minute crescendo alarm with snooze
Pre-alarm for ice alert with programmable time intervals
Blue Backlight
Wall Mount or Table Stand
Power
Main unit : 2 AA batteries
– alkaline are suggested (not included)
Remote Sensor : 2 AA batteries
– alkaline are suggested (not included)
Dimensions
Main unit : 3.68"(L) x 7.31"(H) x 1.31"(D)
Remote sensor : 2.37"(L) x 4"(H) x 1"(D)
17

FCC STATEMENT

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
: -20°C to + 70°C /
(2) This device must accept any interference received,
-4°F to 158°F
including interference that may cause undesired operation.
: - 38°F to 158°F
Warning: Changes or modification to this unit not expressly
( -38.8 C° to 70°C)
approved by the party responsible for compliance could void
: 0.1°C/ 0.2°F
the user's authority to operate the equipment.
: 25% to 90%
NOTE: This equipment had been tested and found to comply
: 1%
with the limits for a Class B Digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
: 433 MHz
provide reasonable protection against harmful interference
: 3
in a residential installation. This equipment generates, uses
: Maximum 100 feet
and can radiate radio frequency energy and, if not installed and
: approximately
used in accordance with the instructions, may cause harmful
45 seconds
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV
technician for help.
18