Full-Osd Time Out Adjustment - Harman Kardon AVR 135 Owner's Manual

Advanced Features
, until the on-screen ©
Press the Button
⁄
cursor is next to the
the Set Button to enter the
menu.
At the
certain that the on-screen © cursor is next to the
line by pressing the
as needed. Next, press the button
›
that the word is shown in the video dis-
play.
Note that this setting is temporary and will
remain active only until it is changed or until the
AVR is turned off. Once the unit is turned off, the
semi-OSD displays will remain activated, even if
they were switched off for the previous listening
session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
Menu as outlined
earlier, and press the buttons
/
⁄ ¤
ed, until the on-screen © cursor is next to the
line. Next, press
the ‹ › Buttons until the desired time
/
in seconds is displayed. Note that unlike most of
the other options in this menu, this is a perma-
nent setting change, and the time-out entry will
remain in effect until it is changed, even when
the unit is turned off.
If you wish to make other adjustments in the
menu, press the Buttons
/
⁄ ¤
screen © cursor is next to the desired setting or
the
press the Set button . If you have no other
adjustments to make, press the OSD Button
to exit the menu system.

Full-OSD Time Out Adjustment

The menu system is used to
simplify the setup and adjustment of the AVR
using a series of on-screen menus. The factory
default setting for these menus leaves them on
the screen for 20 seconds after a period of inac-
tivity before they disappear from the screen or
Time Out. This Time Out is a safety measure to
prevent the menu text from burning into the CRTs
in your monitor or projector, which might happen
if they were left on indefinitely. However, some
viewers may prefer a slightly longer or shorter
period before the Time Out display.
To change the Full-OSD Time Out, you will need
to make an adjustment in the
menu (Figure 11). To start the adjust-
ment, press the OSD button to bring the
to the screen. Press the
, until the on-screen © cursor is next
button
to the line. Press the Set Button
to enter the
menu (Figure 11).
32 ADVANCED FEATURES
At the
certain that the on-screen © cursor is next to the
line. Press
Buttons
/
⁄ ¤
‹ › buttons
/
menu make
displayed in seconds. Note that unlike most of
the other options in this menu, this is a perma-
buttons
/
⁄ ¤
nent setting change, and the time-out entry will
so
remain in effect until it is changed, even when
the unit is turned off.
If you wish to make other adjustments in the
menu, press the
on-screen © cursor is next to the desired setting
or the
press the Set button
adjustments to make, press the OSD Button
to exit the menu system.
If you wish to make other adjustments, press the
Buttons
/
⁄ ¤
is next to the desired setting or the
as need-
Button . If you have no other adjustments to
make, press the OSD Button
menu system.
until the on-
line and
⁄
menu make
line by pressing the
as needed. Next, press the
until the desired time is
Buttons until the
/
⁄ ¤
line and
. If you have no other
until the on-screen © cursor
line and press the Set
to exit the