Philips 7629 Service Manual page 56

2. Use the MENU UP/DOWN keys to highlight the WHITE TONE sub menu.
3. Press the MENU LEFT/RIGHT keys to enter the WHITE TONE sub menu.
4. Use the MENU UP/DOWN keys to select NORMAL RED, NORMAL GREEN, or
NORMAL BLUE.
5. Use the MENU LEFT/RIGHT keys to adjust the value of NORMAL RED, NORMAL
GREEN, or NORMAL BLUE.
6. When all desired changes to the WHITE TONE submenu values are made, press the
MENU button to return to the top level SDAM menu.
7. To ensure the WHITE TONE settings are saved: Turn the television set OFF by using
the POWER button on the remote control transmitter or the local keyboard. Disconnect
the television set from AC power for at least ten seconds. Reconnect the television set
to AC power. Turn the television set ON by using the POWER button on the remote
control transmitter or the local keyboard.
Geometry
The geometry alignments menu contains several Items for correct picture geometry
alignment.
1. Connect the RF output of a video pattern generator to the antenna input.
2. Input a crosshatch test pattern to the television set.
3. Set the amplitude of the video pattern generator to at least 1 mV and set the frequency
to 61.25 MHz (channel 3).
4. Press the AUTO PICTURE button on the remote control transmitter repeatedly to
choose PERSONAL or MOVIES picture mode.
5. Enter SDAM:
Press the following key sequence on the remote control transmitter:
0-6-2-5-9-6-MENU Do not allow the display to time out between entries while keying
the sequence.
6. Use the MENU UP/DOWN keys to highlight the GEOMETRY sub menu.
7. Press the MENU LEFT/RIGHT keys to enter the GEOMETRY sub menu.
8. Use the MENU UP/DOWN keys to highlight either the HORIZONTAL sub menu or the
VERTICAL sub menu.
9. Press the MENU LEFT/RIGHT keys to enter either the HORIZONTAL sub menu or the
VERTICAL sub menu.
10. Use the MENU UP/DOWN keys to select items in the HORIZONTAL sub menu or the
VERTICAL sub menu.
11. Use the MENU LEFT/RIGHT keys to adjust the values of items in the HORIZONTAL
and VERTICAL sub menus.
12. When all desired changes to the HORIZONTAL and VERTICAL sub menu values are
made, press the MENU button twice to return to the top level SDAM menu.