Compair - Philips 7629 Service Manual

Short jumper wires 9631 and 9641 on the monocarrier (see Fig. 8-1) and apply
AC power. Then press the power button (remove the short after start-up).
Caution: Entering SDAM by shorting wires 9631 and 9641 will override the +8V-
protection.Do this only for a short period. When doing this, the service-technician
must know exactly what he is doing, as it could damage the television set.
Or via ComPair (with the ComPair "Tools" RC7150Service Remote, it should be
possible to enter SDAM via the ComPair interface IR).
After entering SDAM, the following screen is visible, with S at the upper right side for
recognition.
Figure: SDAM Menu
Explanation of SDAM Menu
1. LLLL This represents the run timer. The run timer counts normal operation hours,
but does not count standby hours. (maximum four digits displayed).
2. AAABCD-X.Y This is the software identification of the main microprocessor:
A = the project name (L01).
§
B = the region: E= Europe, A= Asia Pacific, U= NAFTA, L= LATAM.
§