Schematic Diagram - Sharp VC-A410U Service Manual

IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH " å " (
IMPORTANT FOR MAINTAINING THE SAFETY
OF THE SET.
BE SURE TO REPLACE THESE PARTS WITH
SPECIFIED ONES FOR MAINTAINING THE SAFE-
TY AND PERFORMANCE OF THE SET.
AVIS DE SECURITE IMPORTANT:
LES PIECES MARQUEES " å " (
IMPORTANTES POUR MAINTENIR LA SECURITE
DE L'APPAREIL.
NE REMPLACER CES PIECES QUE PAR DES
PIECES DONT LE NUMERO EST SPECIFIE POUR
MAINTENIR LA SECURITE ET PROTEGER LE
BON FONCTIONNEMENT DE L'APPAREIL.

SCHEMATIC DIAGRAM

• The indicated voltages in the following diagram
are measured with an SSVM, upon receiving
color bars (400 Hz sound signal) in either the
) ARE
record mode or the play mode voltage is indi-
cated as follows.
NOTE:
1. The unit of resistance "ohm" is omitted (K: 1000
ohms M: 1 Meg ohm).
2. All resistors are 1/8 watt, unless otherwise noted.
3. All capacitors F, unless otherwise noted P:
) SONT
Voltages and waveform are measured as follows:
• DC voltages are measured with an SSVM placed
between points indicated and chassis ground,
with the supply voltage of 120V AC and all
controls for normal positions.
This circuit diagram is a standard one, actual circuits
printed may be subject to change for product
improvement without prior notice.
57
4.0 . . . . Record mode (SP)
(4.0) . . . . PB mode (SP)
4.0 . . . . LP mode
4.0 . . . . EP mode
VC-A410U
VC-H810U
F.