Aeenergy Lithium Ion Polymer Battery Handling Guideline - AEenergy AE8867220PMHRE Product Specifications

AEenergy Li Polymer Rechargeable Battery
Product Specifications– AE8867220PMHRE

8. AEenergy Lithium Ion Polymer Battery Handling Guideline

8.1 In case of contacting the materials from a damaged or ruptured cell or battery:
Eye contact: Washing immediately with plenty of water and soap or for at least 15 minutes. Get
medical attention.
Skin Contact: Washing immediately with water and soap.
Inhalation of Vented Gas: Remove to fresh air. Get medical attention.
Ingestion: Get medical attention immediately.
8.2 Keep away batteries from children.
8.3 The cells/ batteries are requested to be stored within a proper temperature range specified in this
specifications.
8.4 Do not store batteries in a manner that allow s terminals to short circuit.
8.5 Do not place batteries near heating sources, nor exposed to direct sunlight for long periods. Elevated
temperatures can result in reduced battery service life.
8.6 Charging Battery
Use only approved chargers and procedures. Improperly charging a cell or battery may cause the cell
or battery to flame or damage.
Charge the battery using the "CCCV" or constant current /constant voltage method.
Do not charge the battery with a current or voltage higher than the specified maximum value in this
specifications. The absolute maximum charging voltage is 4.25V per cell.
Prohibit reverse charging of the battery. The battery must be connected correctly.
8.7 Discharging Battery
Discharge battery at the max current specified in this specification. If you plan to discharge battery at
a higher current than the max current, please consult AEenergy.
Avoid discharge the battery below 2.75V for each cell.
Do not over-discharge the battery. Over-discharging can damage the performance of the battery. It
should be noted that the cell/battery would be at an over-discharged state by its self-discharge
characteristics in case the cell is not used for long time. In order to prevent over-discharging, the
cell/battery shall be charged periodically to maintain between 3.7V and 4.1V.
Specification Number: AE8867220PMHRE -FPS-Spec1 Version 1 Page 8/13