Schematic Diagrams - Sharp 32U-S50 Service Manual

32U-S50, 32U-S60
36U-S60
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
1. The unit of resistance "ohm" is omitted.
(K=k =1000 , M=M )
2. All resistors are 1/8 watt, unless otherwise noted.
3. All capacitors are F, unless otherwise noted.
(P=pF= F)
4. (G) indicates 2% tolerance may be used.
5. indicates line isolated ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000 V B & W or Color
signal.
1
1.2Vp-p
Horizontal Rate
7
1.1Vp-p
Vertical Rate
e
225Vp-p
Horizontal Rate
o
3Vp-p
Horizontal Rate
WAVEFORMS
2 3
2.3Vp-p 1Vp-p
Horizontal Rate Horizontal Rate
8 9
2.4Vp-p 30Vp-p
Vertical Rate Vertical Rate
r t 1130Vp-p("32")
15Vp-p
1200Vp-p("36")
Horizontal Rate Horizontal Rate
p a
3Vp-p 3Vp-p
Horizontal Rate Horizontal Rate
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
å AND SHADED (
= SAFETY RELATED PARTS.
MARK= X-RAY RELATED PARTS.
ç
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
4 5
0.5Vp-p 5Vp-p
Horizontal Rate Horizontal Rate
0 q
53Vp-p 5.4Vp-p
Vertical Rate Vertical Rate
y 275Vp-p("32")
u
440Vp-p
250Vp-p("36")
Horizontal Rate Horizontal Rate
s d
160Vp-p 150Vp-p
Horizontal Rate Horizontal Rate
16
) COMPONENTS
6
5Vp-p
Vertical Rate
w
0.8Vp-p
Horizontal Rate
i 28.5Vp-p("32")
30.0Vp-p("36")
Horizontal Rate
f
150Vp-p
Horizontal Rate