Sharp XV-Z200U/E Service Manual page 19

* Precautions in setting up the DMD (Digital Micromirror Device) unit
Before connecting the formatter PWB to the optical engine, take the following steps. Look at the voltage rank marking
that is on the DMD itself. Referring to this marking, set the DIP switches on the formatter PWB. And connect this PWB
to the optical engine. Wrong settings will adversely affect the system performance.
DMD Setting: Check the last alphabet character shown in 1, and set the two switches shown in 2 according to the
configurations shown in 3.
Set the formatter PWB switches according to the Bin voltage shown on the back face of the DMD.
2-Dimensional Matrix Code
(DMD Part Number and
Serial Number)
Part 1 of Serial Number
(7 characters)
TI Intemal Numbering
YYYYYYY
*1057-6bbc
CHXXXX L LLL LM
LLLLL
TI Intemal Numbering
1 The last alphabet letter indicates the
2 Set these two switches.
19
DMD Part Number
Part 2 of Serial Number
(6 or7 characters)
Bin voltage setting (B~E).
3
XV-Z200U/E, XV-Z201E
DT-300