Honeywell Chronotherm IV T8611G Installation Instructions Manual page 6

T8611G CHRONOTHERM
Installer Setup
Number (Press
Time
Select change)
Temperature
display
adjustment.
Furnace Air
Filter Timer.
Humidifier Pad
Monitor.
Ultraviolet (UV)
Air Treatment
System Lamp
Monitor.
IMPORTANT
Review the settings to confirm that they match
the system. Press Run Program to exit the
Installer Setup. The thermostat has saved the
Installer Setup changes and initiated a reset in
order to operate using the new settings. Be sure
to set the current day and time immediately.
69-1406—1
®
IV DELUXE PROGRAMMABLE HEAT PUMP THERMOSTATS
Table 3. Thermostat Installer Setup Options. (Continued)
Factory Setting
key to
Display
37 0 No difference in
displayed
temperature and
actual room
temperature.
43 0 Off
44 0 Off
45 0 Off
(Press
Description Display
-3 thru 3
1, 2, 3, 4
1, 2, 3
1
6
Other Choices
or key to change)
Description
1—Display adjusts to 1°F
higher than actual room
temperature.
2—Display adjusts to 2°F
higher than actual room
temperature.
3—Display adjusts to 3°F
higher than actual room
temperature.
-1—Display adjusts to 1°F
lower than actual room
temperature.
-2—Display adjusts to 2°F
lower than actual room
temperature.
-3—Display adjusts to 3°F
lower than actual room
temperature.
1 – 10 days
2 – 30 days
3 – 60 days
4 – 120 days
(Times counted when heat,
cool or fan is running.)
1 – 90 days
2 – 180 days
3 – 365 days
(Times counted by calendar
days in heat mode.)
1 – 365 days
(Times counted by calendar
days in any mode.)
Actual
Setting