Honeywell Chronotherm IV T8602D Installation Instructions Manual page 7

Installer Setup
Number (Press
Time ∆ key to
Select change)
Temperature
display
adjustment.
Furnace Air
Filter Timer.
Humidifier
Pad Monitor.
Ultraviolet
(UV) Air
Treatment
System Lamp
Monitor.
IMPORTANT
Review the settings to confirm that they match
the system. Press Run Program to exit the
Installer Setup. The thermostat has saved the
Installer Setup changes and initiated a reset in
order to operate using the new settings. Be sure
to set the current day and time immediately.
Table 3. Thermostat Installer Setup Options. (Continued)
Factory Setting
Display
37 0
43 0
44 0
45 0
T8602D CHRONOTHERM® IV PROGRAMMABLE THERMOSTATS
Description Display
No difference in 1.5 thru
displayed -1.5
temperature and
actual room
temperature.
Off 1, 2, 3,
4
Off 1, 2, 3
Off
7
Other Choices
(Press or key to change)
Description
.5—Display adjusts to
0.5°C higher than
actual room
temperature.
1.0—Display adjusts to
1.0°C higher than
actual room
temperature.
1.5—Display adjusts to
1.5°C higher than
actual room
temperature.
-.5—Display adjusts to -
.5°C lower than actual
room temperature.
-1.0—Display adjusts to -
1.0°C lower than actual
room temperature.
-1.5—Display adjusts to -
1.5°C lower than actual
room temperature.
1 – 10 days
2 – 30 days
3 – 60 days
4 – 120 days
(Time counted when heat,
cool or fan is running.)
1 – 90 days
2 – 180 days
3 – 365 days
(Time counted by calendar
days in heat mode.)
1 1 – 365 days
(Times counted by
calendar days in any
mode.)
Actual
Setting
69-1510-4