Honeywell TE329ELW User Manual page 6

* Pre-Alarm
If the remote temperature (channel 1) is 32˚F or below,
the pre-alarm feature will be activated. The pre-alarm
time interval can be set for 15, 30, 45, 60, 75 or 90
minutes before the weekday or single alarm time.
This alarm will only sound if either the weekday or single
alarms are armed. This can help you to avoid delays
caused by icy conditions by waking you earlier in case of a
potential ice or snow. This alarm can be bypassed during
the set up if you choose not to use it. If the calendar is
displayed, press ALARM ON/OFF to display the weekday
alarm. Each press on ALARM ON/OFF button will
display the next available alarm in the sequence of
Weekday alarm, Single alarm and Pre-alarm.
Press MODE to return to the calendar display mode.
WEEKDAY ALARM SETTING
1. Press to view the previous weekday alarm time and
arm the alarm.
2. Press to disarm the weekday alarm and have the
display read "OFF".
3. When the weekday alarm time is displayed, press and
hold ALARM ON/OFF for 3 seconds;
4. The alarm hour digit will flash, then press or
adjust the desired hour.
5. Press ALARM ON/OFF again, the alarm minute digit
will flash, then press or
6. Press ALARM ON/OFF again and the weekday alarm
is set with the icon "
W
to
to adjust the desired minute.
" on the display.
SINGLE ALARM SETTING
Press ALARM ON/OFF to select the single alarm. If the
alarm is disarmed, the alarm time will be displayed as
"OFF". If you choose not to set the SINGLE ALARM
press ALARM ON/OFF again to advance to the
PRE-ALARM setting procedure.
1. Press to view the previous single alarm time and arm
the alarm.
2. Press to disarm the single alarm and have the display
read "OFF".
3. When the single alarm time is visible, press and hold
ALARM ON/OFF for 3 seconds;
4. The alarm hour digit will flash, then press
adjust the desired hour.
5. Press ALARM ON/OFF again, the alarm minute digit
will flash, then press or to adjust the desired minute.
6. Press ALARM ON/OFF again and the single alarm is
set with the icon " " on the display.
S
PRE-ALARM SETTING
Press ALARM ON/OFF to select the pre-alarm. If alarm
is disarmed, the alarm time will be displayed as "OFF".
The pre-alarm can be set only if the weekday alarm or the
single alarm is set. If you choose not to set the
PRE-ALARM press ALARM ON/OFF again to exit the
setting procedure.
1. Press to view the previous pre-alarm time and arm
the alarm.
2. Press to disarm the pre-alarm time and have the
display read "OFF".
3. When the pre-alarm time is displayed, press and hold
ALARM ON/OFF for 3 seconds;
4. The minute digit will flash, then press
the desired pre-alarm period in the sequence of 15, 30,
45, 60, 75, 90 minutes.
5. Press ALARM ON/OFF again and the pre-alarm is set
with the icon "PRE-AL" on the display.
or to
or to adjust