Circuit Adjustments; Setting The Service Adjustment Mode; Memory Write Confirmation Method; Adjustment Buttons And Indicators - Sony TRINITRON KV-20FS12 Service Manual

ELECTRICAL ADJUSTMENTS BY REMOTE COMMANDER
Use the Remote Commander (RM-Y168, RM-Y172 or RM-Y173) to perform the circuit adjustments in this section.
NOTE: Test Equipment Required:
• Pattern generator
• Frequency counter
• Digital multimeter
• Audio oscillator

5-1. SETTING THE SERVICE ADJUSTMENT MODE

1. Standby mode (power off).
2. Display
Channel 5
on the Remote Commander (press each button within a
second).
Service Adjustment Mode On
1. The CRT displays the item being adjusted.
SERVICE
2. Press or on the Remote Commander to select an item.
3. Press or on the Remote Commander to change the data.
4. Press then
Service Adjustment Mode Memory
SERVICE WRITE
1. Press then on the Remote Commander to
initialize.
SERVICE RESET
Carry out step 1 when adjusting
IDs 0–4 and when replacing
and adjusting IC1003.
2. Turn set off then on to exit service adjustment mode.
SECTION 5

CIRCUIT ADJUSTMENTS

+
Sound volume Power
Disp. Item
(Item) Data
HSIZ 0
to save into the memory.
MUTING
Green
ENTER Red
KV-20FS12/20FV12/21FE12/A/C/21FM12/21FV12/C

5-2. MEMORY WRITE CONFIRMATION METHOD

1. After adjustment, remove the power plug from the AC
outlet, then plug it in again.
2. Turn the power switch ON and set to service mode.
3. Call the adjusted items again to confirm they were adjusted.

5-3. ADJUSTMENT BUTTONS AND INDICATORS

(Use remote commander RM-Y168, RM-Y172 or RM-Y173.)
MUTING
DISPLAY
1
4
8
VOLUME
— 21 —
POWER
3
5
6
ENTER
RM-Y168