Electronic Ignition
8
Remove the large HEX NUT from the Electronic
Ignition. Insert the EI Module into the hole of the
downside panel left, then use the HEX NUT to secure
the EI Module to the panel (A).
Insert AA battery into ignitor, negative (—) end first.
Screw the Battery Cap to the EI Module (B).
B
Battery Cap
Note: After finishing above step, please check wiring connections whether as below, if not, correct them as below.
Fibre wires, one black
and three whites
Some components are not
shown for the clarification of
illustration
-
+
Battery Positive(+)
side up towards Cap
A
1
2
B
3
4
A
Battery Cap
Hex Nut
Downside panel Left
0
PVC wires, black and red
El Module
Some components are not
shown for the clarification of
illustration
461262508 • 21