Selecting or changing the startup device sequence
To view or permanently change the configured startup device sequence, do the
following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. Select Startup → Startup Sequence. See the information displayed on the right
3. Select the devices for the Primary Startup Sequence, the Automatic Startup
4. Select Exit from the Setup Utility menu and then Save Settings or Save and
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.
Exiting from the Setup Utility program
After you finish viewing or changing settings, press Esc to return to the Setup
Utility program menu (you might have to press Esc several times). If you want to
save the new settings, select Save Settings or Save and exit the Setup Utility.
Otherwise, your changes will not be saved.
52
Hardware Maintenance Manual
page 49.
side of the screen.
Sequence, and the Error Startup Sequence.
exit the Setup Utility.