Making A Call With The Headset - Perfect Choice PC-217237 User Manual

The pairing process is as follows:
1. Place the headset and your Bluetooth® device near each other within one meter.
2. Make sure both devices goes into pairing mode.
3. Once your Bluetooth® device finds the headset (the headset is identified with the
legend: PC-217237) and if a passkey is required just enter the following: 0000 (four
times zero).
4. After the pairing is successfully completed, the blue light will start blinking two or
three times every 4 seconds.
5. You are ready to use your headset.
NOTE: For Bluetooth® devices that do not require a passkey, is necessary to set the
passkey to "0000" on the device before start the pairing process.

Making a call with the headset

Function
Cancel call
Answer call
Reject call
End call
Volume up
Volume down
Transfer a call from
headset to telephone
Transfer a call from
telephone to headset
Mute
Un-mute
Voice Call
Re-dial the last dialed number
Lock/Unlock the buttons
Clean pairing list
Headset Status
While dialing
Incoming call
Incoming call
During the call
During the call
During the call
During the call
During the call
During the call
During the call
(with Mute activated)
Telephone and headset paired
Telephone and headset paired
Telephone and headset paired
While charging
Operation
Press once the multi-function button.
Press once the multi-function button.
Press and hold the multi-function button.
for 2 seconds until you hear a beep.
Press once the multi-function button
Press the "+" button, if you remain pressing the "+".
button the volume will increase continuously.
Press the "-" button, if you remain pressing the "-".
button the volume will decrease continuously.
Press and hold the multi-function button for 2 seconds until you hear a beep.
Press and hold the multi-function button for 2 seconds until you hear a beep.
Press twice the multi-function button.
Press twice the multi-function button.
Press and hold the multi-function button for 2 seconds until you hear a beep.
Press twice the multi-function button in a quick and short way.
Press the multi-function button and the "+".
button at the same time until you hear a beep.
Press the multi-function button and the "-".
button at the same time for 5 seconds until the red LED blinks once.