Proxima DP8400x User Manual page 49

Write Command Examples
Function Command
Brightness (BRT140)
Power (PWRO)
Power (PWR1)
Error Conditions
Not all commands are supported for all projectors. If an unsupported com-
mand is issued, the command will be ignored. If a command is received that
is not understood, a '?' character will be returned indicating the command
was not understood.
Limitations
The projector cannot respond to commands coming in at a high-rate. There-
fore, a delay must occur between commands to ensure that the command
gets properly executed. To assure the projector can process a command,
wait 3 seconds before entering the next command.
The Step column refers to increasing or decreasing the menu bar position
since the On-screen Display is not an exact match of values. For example,
Step 2 changes the data by 2 through the CLI (Command Line Interface).
The menu bar is up (or down) by 1.
Response
Sets the brightness to 140
Turns power off
Turns power on
48
Com-
Function
mand
Auto Power APO at RW
0: disable
1: enable
Aspect Ratio ARZ at RW
0: Native
1: 16:9
2: 4:3
Auto Source ASC at RW
0: disable
1: enable
Balance BAL at RW
Blue Gain BCG at RW
Brightness BRT at RW
Blank Screen BSC at RW
0: black
1: blue
2: white
Blank BLK at W
0: off
1: on
Ceiling CEL at RW
0: disable
1: enable
Color CLR at RW
De-
Min Max Step
fault
0 1 0
0 2 2
0 1 1
0 100 50 1
0 100 50 2
96 160 128 1
0 2 1
0 1 -1
0 1 0
65 191 128 1