Christie 38-VIV212-01 User Manual page 37

SETTING
On start
When this function is "On," projector is automatically turned on just
by connecting AC Power cord to a wall outlet.
Note ; Be sure to turn projector off properly (refer to section
"TURNING OFF PROJECTOR" on P17). If projector is turned
off in wrong steps, On Start function does not operate
properly.
Remote control
This projector has two different remote control codes; factory-set
normal code (Code 1) and secondary code (Code 2). This switching
function prevents remote control operation mixture (jam) when
operating several projectors or video equipment together.
When operating projector in "Code 2," both projector and Remote
Control Unit must be switched to "Code 2."
To change code of Projector;
Set Remote control in SETTING MENU to "Code 2."
To change code of Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit
together for over 10 seconds.
After changing code, make sure Remote Control operates properly.
To return to normal code (Code 1), operate both projector and
Remote Control in ways above again.
ChristieNet
This function can not be adjusted when the ChristieNet (optional
part) is not attached to the projector.
Refer to the owner's manual of the optional ChristieNet for operating
instructions
Lamp counter reset
This function is used to reset Lamp Replace Counter. When
replacing Projection Lamp, reset Lamp Replace Counter by using
this function. Refer to page 38 for operation.
Quit
Closes SETTING MENU.
36
Press SELECT button at this icon to
display other items.
On start
Press SELECT button at this icon to
display previous items.
On
Code 1
Move pointer to item and then press
POINT LEFT/RIGHT button(s).
Lamp
counter reset
On
Code 1
Move pointer to Lamp counter reset and then press
SELECT button. Message "Lamp replace counter
reset?" is displayed.