Grindmaster American Metal Ware LCD2-1 Operation And Instruction Manual page 8

Service and Cleaning (cont.)
Changing the Lightbulb on Stainless Steel Models with a Backlit Merchandiser
(Refer to Figures C and D)
(Refer to serial tag to verify model number of your machine)
WARNING: Disconnect machine from branch electrical supply before changing the lightbulb
Note: The machine uses a F8T5 12" (30cm) 8 watt replacement bulb.
1. Open the merchandiser door.
2. Remove the (2) screws at each end of the lightbulb panel inside the door.
3. The panel will come down to allow the bulb to be changed.
4. Remove the old lightbulb by gently turning the lightbulb 1/4 turn to the left and pulling the bulb from the socket.
5. Install the new bulb by lining the pins on either end of the bulb parallel with the socket opening.
6. Gently insert both ends of the bulb into the socket and turn the bulb 1/4 turn to the right until the bulb locks into
place.
7. Replace the lightbulb panel. Reinstall the screws.
Figure C
Changing the Lightbulb on Models With a Backlit Merchandiser (Refer to Figure E)
(Refer to serial tag to verify model number of your machine)
WARNING: Disconnect machine from branch electrical supply before changing the lightbulb.
Note: The machine uses a F8T5 12" (30cm) 8 watt replacement bulb.
1. Remove the front merchandiser photo and cover by grasping
the edges of the merchandiser.
2. Remove the old lightbulb by gently turning the lightbulb
1/4 turn to the left and pulling the bulb from the socket.
3. Install the new bulb by lining up the pins on either
end of the bulb parallel with the socket opening.
4. Gently insert both ends of the bulb into the socket
and turn the bulb 1/4 turn to the right until the bulb
locks into place.
5. Replace the merchandiser photo and cover.
American Metal Ware Liquid Coffee Dispenser
Figure D
Figure E
Page 8