Sharp AR-122E Service Manual page 79

Main Sub
code code
26 20 Rear edge void setup
When this simulation is executed, the current setup of the rear edge void code number is displayed. Enter the code number
corresponding to the rear edge void and press the PRINT switch to enable the setup.
Code number
0
1
30 CE mark support control ON/OFF
When this simulation is executed, the current setup of the CE mark support code number is displayed. Enter the code number
corresponding to the CE mark support setup and press the PRINT switch to enable the setup.
Code number
0
1
The default for CE-support 200V series is "1."
37 Developer life-over termination cancel
When this simulation is executed, the currently set code number is displayed. Enter a desired code number and press the PRINT
switch, and the new setup is enabled.
Code number
0
1
38 Cancel of stop at drum life over
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
0
1
39 Memory capacity check
When this simulation is executed, the current memory capacity is displayed.
Code number
8
16
40 Polygon motor OFF time setup (Time required for turning OFF after completion of printing)
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the PRINT
switch to enable the setup.
Code number
0
1
2
3
42 Transfer ON timing control setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed. (For any number different from the following
ones, the default time is automatically set.)
Code number
0
1
2
3
4
5
6
7
8
9
Rear edge void setup
Rear edge void provided * Default
Rear edge void not provided
CE mark support setup
CE mark support control OFF * Default (100V series)
CE mark support control ON
Setup
Developer life-over termination
Developer life-over termination cancel
Setup
Stop at drum life over * Default (AL model)
Cancel of stop at drum life over
Setup
8 Mbyte
16 Mbyte
Setup
0 sec
30 sec * Default
60 sec
90 sec
Setting
Default (330 msec)
–40 msec
–30 msec
–20 msec
–10 msec
Default (330 msec)
+10 msec
+20 msec
+30 msec
+40 msec
AR-122E/152E/153E/157E SIMULATION, TROUBLE CODES 10 - 7
Content