Table of Contents
Advertisement
EN 18
5.
TCM3.1L LA
5.7
Software Upgrading
5.7.1
Introduction
It is possible for the user to upgrade the main software via the
USB port. A description on how to upgrade the main software
can be found in the DFU and below.
5.7.2
Main Software Upgrade
In "normal" conditions, so when there is no major problem with
the TV, the main software and the default software upgrade
application can be upgraded with the "upgrade.bin". This can
also be done by the consumers themselves via the Software
Update Assistant in the user menu (see DFU), but they will
have to download their software from the commercial Philips
website.
How to upgrade (see also figure 5-9 User SW upgrade
flowchart):
1. Copy the "upgrade.bin" file to the root of the USB stick.
2. Power "off" the TV and remove all memory devices.
3. Insert the USB stick that contains the downloaded software
upgrade.
4. Switch "on" the TV, and activate the Main menu with the
"Menu/House" key on the remote control.
5. In the Main menu, go to the "Software update" item.
6. Press "OK" key to go to the submenu.
7. Select "Local updates" in the submenu and press the "OK"
key to enter the Software Update application.
8. You will be prompted to cancel or to proceed with the
software updating.
9. To proceed, select "Update" and press the "OK" key to
enter the next menu. In the next menu select "Start" and
press "OK" key to start the software update.
10. Upgrading will now begin and the progress of the updating
will be displayed. After the software updating is completed,
the TV will automatically restart.
5.7.3
Stand-by Software Upgrade
In this chassis it is not possible to upgrade the Stand-by
software via a USB stick or ComPair. Please order a pre-
programmed device via the Philips Spare Part web portal.
2009-Jun-05
Service Modes, Error Codes, and Fault Finding
5.7.4
5.7.5
Upgrade HDMI EDID NVM
To upgrade the HDMI EDID, pin 7 of the EDID NVM [1] has to
be short circuited to ground. See ComPair for further
instructions.
1
Figure 5-6 HDMI-1 EDID NVM
Figure 5-7 HDMI-side EDID NVM
Upgrade VGA EDID NVM
To upgrade the VGA EDID NVM, pin 7 of the EDID NVM [2] has
to be short circuited to ground. See ComPair for further
instructions.
2
Figure 5-8 VGA EDID NVM
18520_208_090313.eps
090313
1
18520_210_090313.eps
090313
18520_209_090313.eps
090313
Hide quick links:
Advertisement
Table of Contents
