Siemens SATURN IIE EPABX Installation Test Procedures page 42

SATURN IIE EPABX
Test Procedures
S T E P
7 Depress the DTMF keypad buttons in
the following sequence:
For 12-button phones: 1, 2, 3, 4, 5, 6,
For 16-button phones: A, B, C, D, 1,
2, 3, 4, 5, 6, 7, 8, 9, 0, * and #.
8 level of test tone by using
9 Place DTMF station under test on-
hook to terminate test.
1 0 If no additional apparatus tests are to
be performed, proceed as foilows:
Place maintenance
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Dial 2 to disable the Apparatus Tests.
P l a c e m a i n t e n a n c e t e s t p h o n e N o n e .
on-hook.
N O T E S : 1 ) If the system option flag TSTDIAG has been enabled in the data base, the maintenance test phone is not required
to enable and disable the Apparatus Test routines; therefore, perform only steps 5 through 9.
2) If the system option flag TSTDIAG has been disabted in the data base, the maintenance test phone is required
to enable and disable the Apparatus Test routines; therefore, perform the entire procedure (steps 1 through 10).
S T E P PROCEDURE
1 Place maintenance
off-hook.
2 D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
3
Dial 3 to enable the Apparatus Tests.
4
P l a c e m a i n t e n a n c e t e s t p h o n e N o n e .
on-hook.
5
At the Console under test dial the At-
when the console is in an idle state.
6 - 1 6
VERIFICATION
Recall dial tone ceases. After all the
in the sequence indicated, test tone
one minute.
N o n e .
test phone Dial tone is returned.
Recall dial tone is returned.
N o n e .
Table 6.05 Console Test
VERIFICATION
test phone Dial tone is returned.
Recall dial tone is returned.
Confirmation tone is returned.
Recall dial tone is returned. Also the
access code is displayed momentar-
ily, then the display changes to CON- retry later.
SOLE TEST and all button LEDs are
extinguished.
Issue 1, May 1986
IS NOT OBTAINED
If busy tone is returned at any time,
e i t h e r t h e D T M F k e y p a d b u t t o n s w e r e
depressed in the wrong sequencethe
D T M F k e y p a d o f t h e s t a t i o n u n d e r t e s t
is defective or the subscriber line cir-
cuit is defective.
T o l o c a t e f a i l u r e , r e t r y t e s t t o v e r i f y t h a t
t h e k e y p a d b u t t o n s w e r e n o t
d e p r e s s e d o u t o f s e q u e n c e . I f
problem persists, swap the station in-
s t r u m e n t t o d e t e r m i n e
If problem remains, replace the rp-
propriate subscriber line PCB.
If the measured test tone is correct
but is weak, replace the station set.
If the measured tone is low, rep!ace
the subscriber line PCB SLMA or
IF VERIFICATION
IS NO-i- OBTAINED
If reorder tone is returned, the Atten-
dant Console Test routine is in use,