Table of Contents
Advertisement
SATURN IIE EPABX
Installation Test Procedures
S T E P
1
Place
maintenance
off-hook.
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Dial # for DTMF receiver test.
Dial the four-digit PEN number of the
DTMF receiver circuit to be tested.
5
Depress the maintenance test phone
keypad's buttons in the following se-
q u e n c e .
a) For 12-button phones: 1, 2, 3,
4, 5, 6, 7, 8, 9, 0, *and #.
b) For 16-button
phones: A, B, C,
and #.
If additional tests or procedures are
to be performed, hook-flash main-
tenance tes? phone and dial the next
code (Diagnostic Test Access Code is
not redialed).
I f n o a d d i t i o n a l t e s t s o r p r o c e d u r e s a r e
to be performed, place the main-
tenance test phone on-hook.
NOTES: 1) If the system option flag TSTDIAG has been enabled in the data base or the station under test is c!assmarked
with the TSTAPP feature, the maintenance test phone is not required to enable or disable the Apparatus Diagnos-
tic Test routines; therefore, perform only steps 5 through 10.
2) If the system option flag TSTDIAG has been disabled in the data base or the station under test is not classmarked
with the TSTAPP feature, the maintenance test phone is required to enable or disable the Apparatus Diagnostic
Test routines; therefore, oerform the entire procedure (steps 1 throuqh 11).
STEP
PROCEDURE
Place
maintenance
off-hook.
D i a l t h e D i a g n o s t i c T e s t A c c e s s C o d e .
Dial 3 to enable the Apparatus tests.
Place the maintenance test phone
on-hook.
Place the station under test off-hook.
Test-Station Line Access
6 - 1 4
Table 6.02 D T M F Receiver Test
Dial tone is returned.
test
phone
Recall dial tone is returned.
N o n e .
Dial tone returned and the associat-
ed DTMF receiver circuit LED in the
DTMF PCB is lit steadily.
T e s t t o n e (1004Hz
returned.
Recall dial tone is returned and the
in the DTMF PCB is extinguished.
The associated DTMF receiver circuit
LED in the DTMF PCB is extin-
guished.
Table 6.03 Station Line Test
VERIFICATION
Dial tone is returned.
test
phone
Recall dial tone is returned.
Confirmation tone is returned.
N o n e .
Dial tone is returned
Confirmation tone is returned.
IF VERIFICATION
IS NOT OBTAINED
If busy tone is returned, the DTMF
receiver circuit is busy. Retry later. If
intercept tone is returned, the DTMF
receiver circuit is not assigned (check
data base assignment).
a t - 1 6 d B m )
If intercept tone is returned at any
time, either the DTMF receiver or the
maintenance phone's key-pad is nc?
operating properly, or the buttons
were depressed in the wrong se-
quence. Retry test with another DTMF
phone. If intercept tone is returned
again, replace the DTMF receiver
circuit.
IF VERIFKATION
IS NOT OBTAINED
Issue 1, May 1986
Advertisement
Table of Contents
