Table of Contents
Advertisement
RECOMMENDED CONTINUOUS (RMS) POWER RANGE FOR ONE SUBWOOFER DRIVER:
5 0 0 W
7 5 0 W
Amplifier Recommendation:
JL Audio 1000/1v2:
These settings are intended
as a "baseline" for tuning
your system. Depending
on your vehicle and your
preferences, some variation in
the crossover and bass control
settings may be necessary
for optimum performance.
= position of knob
= position of switch
= switch with two possible positions
= setting will vary (see sidebar)
6
1 0 0 0 W
1 5 0 0 W
Bass EQ:
Generally not necessary in W7 applications (we recommend defeating it by
switching the
Control to provide some user controllable broad bass boost. When used in this
manner, set
to
connection of Remote Bass Control.
Infrasonic Filter:
Turn
for
.
Turn
for
and
set the knob to
Hz.
Remote Bass Port:
Amp Low-Pass Filter:
Permits connection of an
Set
optional remote bass boost
Set
controller (RBC-1), giving you
Lower settings are likely to result in a
control over the boost of the
poor transition between the upper
parametric EQ from the front
response of the W7 and the lower
of the vehicle. The RBC-1
response of the mid-bass speakers.
controller is sold separately.
13W7-D1.5
Free Air Resonance (Fs): 23.5 Hz
Electrical "Q" (Qes): 0.476
Mechanical "Q" (Qms): 7.517
Total Speaker "Q" (Qts): 0.448
Equivalent Compliance (Vas): 3.68 cu. ft. (104.3 ltrs)
One-Way, Linear Excursion (Xmax)*: 1.25 in. (32 mm)
Thermal Power Handling (Pt): 1500 Watts Continuous
Reference Efficiency (no): 0.269 %
Efficiency (SPL @ 1W/1m): 86.3 dB
DC Resistance (Re): 2.41Ω
Effective Piston Area (Sd): 107.35 sq. in. (0.0693 sq. m)
Nominal Impedance (Znom): Dual 1.5Ω
* Xmax specifications are derived via one-way voice coil overhang
method with no correction factors applied.
** For parallel-wired voice coils, divide "Re" by 4.
All other specifications remain the same.
2 0 0 0 W
1000/1v2
switch to
). May be used with Remote Bass
, set
to
Hz,
is defeated by
Input Sensitivity Controls:
Proper adjustment of these controls is critical!
For virtually all aftermarket head units,
set
to
See
on pg. 14 for precise setting instructions.
Amplifier Input:
switch to
.
Connect RCA-type
knob to
.
cables from the head
unit (or processor) to
these two jacks.
Use both jacks
(with a Y-adapter
if necessary).
Dual Mono Speaker
Output Connections:
.
Connect wire directly to
and
connections and to the W7.
Output Polarity:
Carefully listen to the sub-bass to
mid-bass transition with music that
has strong mid-bass content. Select
the switch position which gives the
smoothest, most natural mid-bass
response. If using multiple 1000/1's
on multiple subwoofers, make sure
this switch is set to the same position
on all amplifiers.
Hide quick links:
Advertisement
Table of Contents
