Table of Contents
Advertisement
RECOMMENDED CONTINUOUS (RMS) POWER RANGE FOR ONE SUBWOOFER DRIVER:
2 5 0 W
5 0 0 W
Amplifier Recommendation:
JL Audio 500/1v2:
These settings are intended
as a "baseline" for tuning
your system. Depending
on your vehicle and your
preferences, some variation in
the crossover and bass control
settings may be necessary
for optimum performance.
= position of knob
= position of switch
= switch with two possible positions
= setting will vary (see sidebar)
10
7 5 0 W
1 0 0 0 W
500/1v2 (pictured), HD750/1
or G-MAX
Bass EQ:
Generally not necessary in W7 applications (we recommend defeating it by
switching the
switch to
Control to provide some user controllable broad bass boost. When used in this
manner, set
to
, set
connection of Remote Bass Control.
Infrasonic Filter:
Turn
for
.
Turn
for
and
set the knob to
Hz.
Remote Bass Port:
Amp Low-Pass Filter:
Permits connection of an
Set
optional remote bass boost
Set
controller (RBC-1), giving you
Lower settings are likely to result in a
control over the boost of the
poor transition between the upper
parametric EQ from the front
response of the W7 and the lower
of the vehicle. The RBC-1
response of the mid-bass speakers.
controller is sold separately.
10W7-3
Free Air Resonance (Fs): 30.6 Hz
Electrical "Q" (Qes): 0.578
Mechanical "Q" (Qms): 7.647
Total Speaker "Q" (Qts): 0.537
Equivalent Compliance (Vas): 1.28 cu. ft. (36.1 ltrs)
One-Way, Linear Excursion (Xmax)*: 0.9 in. (23 mm)
Thermal Power Handling (Pt): 750 Watts Continuous
Reference Efficiency (no): 0.171 %
Efficiency (SPL @ 1W/1m): 84.3 dB
DC Resistance (Re): 2.75Ω
Effective Piston Area (Sd): 59.8 sq. in. (0.0386 sq. m)
Nominal Impedance (Znom): 3Ω
* Xmax specifications are derived via one-way voice coil overhang method with
no correction factors applied.
2 0 0 0 W
). May be used with Remote Bass
to
Hz,
is defeated by
Input Sensitivity Controls:
Proper adjustment of these controls is critical!
For virtually all aftermarket head units,
set
to
.
See
on pg. 14 for precise setting instructions.
Amplifier Input:
switch to
.
Connect RCA-type
knob to
.
cables from the head
unit (or processor) to
these two jacks.
Use both jacks
(with a Y-adapter
if necessary).
Dual Mono Speaker
Output Connections:
Connect wire directly to
and
connections and to the W7.
Hide quick links:
Advertisement
Table of Contents
